EPSON Stylus COLOR 850
6 -
EPSON Stylus COLOR 850
3/98
Control Panel
Follow these guidelines when the control panel lights come on
or flash:
Testing the Printer
You can run a self test to determine whether the problem
comes from the printer itself or some other source.
❏ If the results are satisfactory, the problem lies in your
software settings, the interface cable, or your computer.
❏ If the self test does not print correctly, you have a problem
with your printer.
Follow these steps to run the test:
1. Make sure both the printer and computer are turned off.
2. Disconnect the interface cable from the printer.
3. Make sure paper is loaded in the printer.
Caution:
Load paper that’s at least 8.27 inches (210 mm) wide. This
prevents ink from spraying inside the printer and smudging your
printouts.
4. Hold down the
E
l
oad/eject button and press the
Ppower
button. Hold down the buttons until the
Ppower light
starts to flash, then release them.
5. The printer prints a nozzle check pattern (shown on
page 10) and samples of fonts and colors.
6. To end the test, turn off the printer. Then reconnect the
interface cable and turn on your printer and computer.
Using Hex Dump Mode
You can use the printer’s hex dump mode to identify problems
if you know how to interpret hex code. Follow these steps:
1. Make sure the printer is turned off and has paper loaded
in it.
2. Open the cover.
3. Hold down the
E load/eject button and the
X color
cleaning button and press the
Ppower button. The printer
prints Hex Dump Mode at the top of a page and then
stops.
4. Print one or more pages from an application as usual. The
printer prints the exact code it receives in hexadecimal
format.
5. Turn off the printer to exit hex dump mode.
Installing Ink Cartridges for the
First Time
Follow these steps to install the ink cartridges that came in the
box with the printer for the first time:
1. Make sure the printer is turned off (the
P power button
should be up). Then plug the printer’s power cord into a
grounded outlet.
Caution:
Always use the
P
power button to turn the printer on or off. Never
use an external switch—such as a power strip switch—to turn off
the printer.
Don’t use an outlet that can be turned off by a wall switch or timer,
or one that uses the same circuit as a large appliance. This may
disrupt the power, which can erase memory or even damage the
printer’s power supply.
S
When the paper out light
flashes
, paper is jammed in
the printer. Turn off the printer and gently pull out all
paper. Then press the
E
load/eject button.
S
When the paper out light
comes on
, your paper ran
out or is incorrectly loaded. Load paper in the feeder
and then press the
E
load/eject button.
B A
When an ink out light
flashes
, your ink supply is low.
Make sure you have a replacement cartridge.
B A
When an ink out light
comes on
, you need to replace
the ink cartridge.
P S B A
When the power light and paper out light
flash
and all
the other lights are on, your printer has a carriage
error.
P S B A
When all the lights
flash
, your printer may have an
internal error.
power button
load/eject button
color cleaning
button
black cleaning
button
paper out light
color ink out light
black ink out light
power light
(16 strony)
(88 strony)
(92 strony)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji