Epson Powerspan Dokumentacja Strona 323

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 515
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 322
Test Procedure (ZVM & ZVK) ZVx
1127.8500.60 5.2 E-2
5.2 Test Procedure (ZVM & ZVK)
The rated specifications of the network analyzer are checked after a warm-up time of at least one hour.
Only this warmup ensures that the specifications are complied with.
The values stated in the following are not guaranteed. Only the data sheet specifications shall be bind-
ing.
In order to guarantee the specified data, the measured value has to be < specification - expanded un-
certainty (k = 2, confidence level of 95%).
The expanded uncertainty (k = 2) obtained with the proposed measuring equipment / test procedures is
given in the test record. Influences, which are exclusively within the user’s responsibility (e.g. cable at-
tenuation in harmonics measurements), are not taken into account in the specified measurement un-
certainty and should be at least estimated by the user.
In case of a deviating test configuration, the user has to calculate the corresponding measurement un-
certainties.
5.2.1 Checking the Generator Specifications
5.2.1.1 Frequency Deviation
Test equipment: FSEK30, test cable
Test setup: ½ Connect FSEK30 (Marker COUNTER mode, resolution 1 Hz) to PORT1 of the
network analyzer.
Settings on network analyzer:
PRESET
CENTER Measurement frequency
SWEEP SINGLE POINT
SWEEP TIME 255 s
SOURCE POWER Level: -10 dBm
MEAS INPUT a1
Measurement: ½ Set measurement frequencies according to test record.
Deviation: Frequency value displayed on FSEK30 minus
setting value.
Przeglądanie stron 322
1 2 ... 318 319 320 321 322 323 324 325 326 327 328 ... 514 515

Komentarze do niniejszej Instrukcji

Brak uwag