Epson C82324* Instrukcja Obsługi Strona 107

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 106
DFX-5000+
Service Manual
Disassembly and Assembly
3.2.7.6 Removing the Upper Paper Guide and
Top PE Sensor
1.
Remove the paper bail assembly. (Refer to Section 3.2.7.5)
2.
Disconnect the red, 3-pin, top PE sensor connector from the
comector
junction board
assembly. (Refer to
Section
3.2.73)
3. Remove the 2
CPS
(M4
x 6) screws securing the upper paper guide to both frames and remove
the paper guide.
4. Release the 2 notches for the top PE sensor cover and remove the cover.
5.
Remove the 2
CPS
(SP)
(M3
x 8) screws securing the top PE sensor to the upper paper guide
and remove the sensor.
UPPER
PAPER END SENSOR
UPPER PAPER GUIDE
\
CPS
(M4x6)
Figure 3-39. Removing the
Top
PE
Sensor
3.2.7.7 Removing the Tension Roller Shaft
This section describes how to remove the tension roller shaft. It is easiest to remove the tension
roller shaft when the paper bail assembly is removed; however, removing it is not required.
(Refer to Section 3.2.7.5 for instructions on how to remove the paper bail assembly.)
c)
.,
.
.
.,
1.
Remove the
comector
junction board assembly. (Refer to Section 3.2.73)
2. While pushing on the tension pulley, remove the
CRtimingbelt. (Refer to Section 3.2.7.19)
3. Remove the upper paper guide. (Refer to Section 3.2.7.6)
4. Remove the tension roller gear on the left side of the tension roller shaft by pulling it left and
lifting the clip section with tweezers.
PLATEN
ROLLER SHAFT HOLDER
Figure 3-40. Removing the Tension Roller Gear
Rev. A
3-31
Przeglądanie stron 106
1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 185 186

Komentarze do niniejszej Instrukcji

Brak uwag