Auto Take-up Reel Unit User’s Guide®English . . . . . .XXXXXXX-XXXXX-00
8
Printed in Japan 00.xx-xx
All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electron
1Safety InstructionsImportant safety instructionsRead all of these instructions and save them for later reference. Follow all warnings and instruction
2Checking the Package ContentsMake sure that all the items shown below are included and not damaged. Remove all protective materials packed with this
3Installing the drive unit1. Attach the drive unit on the horizontal strut as shown below.2. Tighten the two screws to attach the drive unit to the pr
4Installing the sensor unitThe sensor components are shown below.1. Set the sensor unit’s light emitter in the bottom of the drive unit, and then secu
5Installing the 3-inch take-up reel coreNote:If you want to install a 2-inch take-up reel core instead, see the next section for instructions. Also yo
63. Remove the flange.4. Reverse the flange so that the smaller knob is positioned on the outside, then replace it on the drive unit.5. Replace the ca
7Using the core from a used paper roll as a take-up reel coreBefore you install a used paper roll as the take-up reel core, note and check the followi
Komentarze do niniejszej Instrukcji