Epson UB-E02 Dokumentacja Pobierz pdf (Strona 20)

2-4 Installation Rev. A

3. Tighten the screws.

If you have removed an interface circuit board that was already installed, fix the UB-E02

using the removed screws.

4. Plug the twist pair cable into the 10BASE-T/100BASE-TX Ethernet connector of the UB-E02

until it clicks.

CAUTION:

Be sure not to connect a telephone line, display module connector, or drawer kick-out

connector cable to the 10BASE-T/100BASE-TX Ethernet connector of the UB-E02.

The display module connector on the TM printer cannot be used when the UB-E02 is

installed.

5. Connect the power unit to the printer.

6. Turn on the printer power.

Note:

When initializing the UB-E02 by turning off the power and then turning it back on or by resetting the

printer, there is a waiting time until the network starts operating. During this time, all the

communicating functions of the network do not work.

The waiting time is:

When the IP address setting is Manual (Fixed): approximately 6 seconds

When the IP address setting is Auto: approximately 13 seconds

(It can be longer, depending on the reply time of

the host.)

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 83 84

Brak uwag

Epson UB-E02 Dokumentacja Strona 20