Epson ActionPC 6000 Podręcznik Użytkownika Strona 73
- Strona / 144
- Spis treści
- ROZWIĄZYWANIE PROBLEMÓW
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
Follow these steps to install video memory chips:
1.
2.
3.
4.
5.
6.
7.
Locate the video memory chip sockets on the left side of the
main system board, shown on page 4-5. The chip sockets
are labelled U53 and U57.
If there is an option card in your way, remove it. See
page 4-18 for instructions.
Caution
To avoid generating static electricity and damaging the
memory chips, ground yourself by touching the metal
surface on the inside of the computer’s back panel. Then
remain as stationary as possible while you install them.
Position the chip over the socket and align the notch in the
chip’s corner with the notch in the corner of the socket.
Gently press the chip into the socket; then push down firmly
on both ends to make sure it is well-seated.
Repeat steps 3 and 4 to install the other chip.
Replace any option cards you removed; see page 4-15.
Now run SETUP as described in Chapter 2 so that your
system recognizes the increased video memory.
Installing and Removing Options
4-19
- IMPORTANT NOTICE 2
- DISCLAIMER OF WARRANTY 2
- COPYRIGHTNOICE 2
- Important Safety Instructions 3
- Contents 5
- USING YOUR COMPUTER 6
- TROUBLESHOOTING 7
- SPECIFICATIONS 8
- GLOSSARY 8
- Introduction 9
- Power-saving Features 10
- SVGA and lDE Drivers 11
- How to Use This Manual 12
- Where to Get Help 13
- CompuServe On-line Support 14
- Setting Up Your System 15
- 1-2 Setting Up Your System 16
- Connecting System Components 17
- Connecting a Monitor 18
- Using the parallel port 20
- Using the serial ports 20
- 1-6 Setting Up Your System 20
- Connecting the Power Cord 21
- Turning On the Computer 21
- 1-8 Setting Up Your System 22
- Turning Off the Computer 23
- 1-10 Setting Up Your System 24
- Chapter 2 25
- Starting the SETUP Program 26
- Using the System Setup Option 27
- Setting the time and date 28
- Checking system memory 28
- Setting the diskette drive(s) 28
- Defining your own drive type 30
- Configuring cache memory 30
- Configuring shadow memory 31
- Setting the Boot Options 32
- Numlock option 33
- Key click option 33
- Selecting password types 34
- Selecting password prompting 34
- Deleting passwords 35
- Using the Green PC Features 37
- Exiting SETUP 38
- Post-SETUP Procedures 39
- InstaIling the IDE Drivers 39
- INSTALL4 and press Enter 40
- InstaIling Video Drivers 41
- Using Your Computer 43
- Using the Right Furniture 44
- Positioning Your Monitor 45
- Lighting Your Workspace 45
- Using the Keyboard and Mouse 46
- Using Energy Wisely 48
- Using Your Green PC Featutes 48
- Stopping a Command or Program 50
- Resetting the Computer 51
- Using a Password 52
- Changing the Processor Speed 53
- Chapter 4 55
- Removing the Cover 56
- Replacing the Cover 58
- Changing the Jumper Settings 61
- SVGA jumper settings 62
- Setting the Jumpers 63
- SIMM configurations 64
- Inserting SIMMs 66
- Removing SIMMs 67
- Installing an Option Card 69
- Removing an Option Card 72
- Adding Video Memory 72
- InstaIling External Cache 74
- Chapter 5 77
- Removing the Mounting Frames 81
- Connecting the Drive Cables 84
- InstaIling the Drive 93
- Post-installation Procedures 98
- Troubleshooting 99
- The Computer Will Not Start 100
- The Computer Does Not Respond 102
- Keyboard Problems 102
- Mouse Problems 103
- Monitor Problems 103
- Diskette Problems 105
- Diskette Drive Problems 106
- Hard Disk Drive Problems 106
- Password Problems 108
- Software Problems 109
- Printer or Scanner Problems 110
- Option Card Problems 110
- Memory Module Problems 111
- Controller Problems 112
- External Cache Problems 112
- Specifications 113
- Controllers 114
- Interfaces 115
- Keyboard 116
- Physical Characteristics 118
- Environmental Requirements 118
- Options Available from EPSON 118
- Tested Operating Environments 119
- System Memory Map 119
- Video Resolutions and COIOrS 120
- Hard Disk Drive Types 121
- A-10 Specifications 122
- Drive Option Information 123
- DMA Assignments 124
- Hardware Interrupts 125
- System I/O Address Map 125
- A-14 Specifications 126
- Connector Pin Assignments 127
- A-16 Specifications 128
- Glossary 129
- Memory module 130
- True Color 132
- Write-protect 132
- 4 Glossary 132
- 1-3, 1-7, 6-3 133
- 2 Index 134
- 4 Index 136
- Index 5 137
- 6 Index 138
- Index 7 139
- 8 Index 140
- Epson America (USA) 141
- EPSON America (International) 141
- Distributors 143
© 2020, manymanuals.pl. Wszelkie prawa zastrzeżone. | 0.043 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji